Home SET Asylum

Single Ended Triodes (SETs), the ultimate tube lovers dream.

Some basic questions

Thanks for the corrections drummerwill. I want to build this amp, so please indulge me to ask a few basic questions.

1.)First, where should I connect the other primary line of the 5U4 filament transformer?

2.) Why are the B2+Lch (332V)and B2+Rchn (339v) voltages different and the voltage is 337v on the signal schematic?

3.) You show no values for the bypass caps. What are good starting values for the 26 and 45 tubes?

4.) There's a cap after the 24uf 630V in the PS with no specified value. Is it necessary?

5.) I would need two dual 26 supply, one for each channel, correct?

6.) Would two 5VDC 3A Wall Adapter Power Supply work for the 26 filament supplies or.. ?

7.) Two 2.5Vac transformers and associated caps and resistors, one for each channel are needed, correct?

8.) Can you direct me to a schematic for a LM335 based regulator? My searches shows the IC as a temp. sensor.

9.) I may have more questions later. I really need to build this amp!!

Thanks again for taking the time to share your work.
Regards,
David



Edits: 01/18/15

This post is made possible by the generous support of people like you and our sponsors:
  K&K Audio / Lundahl Transformers   [ K&K Audio / Lundahl Transformers Forum ]


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.