In Reply to: How to connect the Tango XE-20S OPT? posted by iodemus on January 12, 2015 at 23:52:19:
The dots are phase dots, i.e., they tell you the start of the winding, from there you apply the right hand thumb rule.
http://electronics.stackexchange.com/questions/66708/dots-in-a-transformer-symbol
3 = B+
4 = screen grid, if you have one; otherwise not connected
5 = plate of the output tube
Typically,
8-12 is the selects the desire reflected primary Z
1 = Ground
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: How to connect the Tango XE-20S OPT? - larrymoore@ultrafi.biz 07:07:50 01/13/15 (1)
- RE: How to connect the Tango XE-20S OPT? - double28 10:24:47 01/13/15 (0)