In Reply to: RE: Adding parts ........ posted by drlowmu on December 16, 2014 at 07:33:33:
I have already drilled to use a M12 SVT type strain relief for the power cord.
I usually file for IEC sockets but didn't feel like it this time around.
Other then the occasional convenience and looking a little better, I don't really need the IEC socket.
So the pigtail does away with the connection all together.
This does limit the wire to SVT sizes, in my case 18awg as the 16awg SJT wires I had for the IEC sockets don't fit through the SVT pigtail.
I will check it out, although I don't put much credence beyond the usual engineering as far as wires go. I am more concerned with conforming to codes as much as possible.
I mean realistically if one felt the need for 12awg wiring it would make sense to not use the IEC at all, but then comes the challenge of trying to safely secure that thick of wire to the chassis.
Cheers
△This message will self destruct in 10 seconds△
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Adding parts ........ - Garg0yle 08:29:49 12/16/14 (1)
- RE: Adding parts ........ - drlowmu 10:38:43 12/16/14 (0)