In Reply to: RE: AES SE-1 Blowing Fuses posted by returntohifi on September 15, 2014 at 17:02:49:
It is clear that too much current caused the failure. We could speculate endlesly about what 'might' have happended; now is the time to start trouble shooting. What voltage did you measure when you turned on the amp in "standby" (or remove all the tubes) and measured the the filament wires?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: AES SE-1 Blowing Fuses - Palustris 09:26:54 09/16/14 (1)
- RE: AES SE-1 Blowing Fuses - returntohifi 17:34:10 09/16/14 (0)