Home SET Asylum

Single Ended Triodes (SETs), the ultimate tube lovers dream.

OK, I read the article

"The next two curves make the further
assumptions that an Off/On cycle will remove 60
hours of life from the filament at the rated filament
voltage. It amounts to a 0.2 percent reduction in the
life of the tube, another way of saying that the filament
is good for about 500 Off/On cycles at the rated
filament voltage before burnout"

But if each cycle reduces the life of the tube by .2% then even though the first cycle will remove 60hrs the 200th would only remove 40.44hrs because by then the hours left would only be 20222.64 as each cycle leaves the filament with less hours of life left.

So .2% of 20222.64 is not 60hrs, it's 40.44hrs

I guess my point is the article should not have stated a percentage of filament life lost, it should have stated just the number of hours lost with each cycle if that's what they meant.

If each cycle removes 60hrs then the 499th cycle is removing much more than .2% of the remaining life of the filament and the 500th cycle will remove 100% of the remaining life of the filament.

This is all made clear in the linked spread sheet.

Check it out, you might at least get a laugh that I would take the time to create the spread sheet over an article that has very little to do with the types of tubes we use for audio.

Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"



Edits: 06/24/14 06/24/14

This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.