In Reply to: RE: 300B run conservatively? posted by Vincin on April 4, 2014 at 08:22:10:
Hi,> I have my 300b tube run with B+410v, 85ma, Rk 750ohm, 2k7 OPT, 8Ohm tap.
> To switch to your suggested, I guess I could just replace the cathode
> resistor with 1Kohm, and use the 4Ohm tap?Maybe 1.2KOhm, rather than 1k.
But yes, you could try.
> How much power do I expect to drop?
It's all in the WE datasheets.
> My speakers are the AN-E with the hemp cones, which has 6Ohm impedance
> I think. Will you expect the 350v/60ma/4Ohm tap to work?I don't expect much higher power operating points to work.These are rather low efficiency speakers.
> On the other hand, to squeeze a few more watts from the 300b amp
> (which is more applicable in my case with the speakers I have) what
> is a reasonable operating point?I used 400V/80mA/3K in the diyhifisupply Lux 91, together with a choke loaded cathode follower. That started as a custom build for someone with AN-E's...
Thor
At 20 bits, you are on the verge of dynamic range covering fly-farts-at-20-feet to intolerable pain. Really, what more could we need?
Edits: 04/04/14
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: 300B run conservatively? - Thorsten 09:20:58 04/04/14 (1)
- RE: 300B run conservatively? - shane. 02:07:23 04/17/14 (0)