Power Forum

Posted by PaulMC (M) on January 26, 2009 at 14:08:22

In Reply to: RE: How do I tell if I have a 200C or 200CX posted by SQLGuy on January 18, 2009 at 20:14:07

It's all pretty fuzzy. I would guess the resistors between the drivers and the outputs were there to increase the impedance of the output devices and to make it easier to drive the outputs. If I were building the amp today I would certainly remove them and I would lower the 83 Ohm resistor to something smaller and run a bit more current through the drivers.

I would think the amp you have is better than the one on the schematic.

• RE: How do I tell if I have a 200C or 200CX - SQLGuy 14:14:22 01/26/09 (8)
  • RE: How do I tell if I have a 200C or 200CX - PaulMC 17:56:56 01/26/09 (7)
    • RE: How do I tell if I have a 200C or 200CX - SQLGuy 06:06:11 03/09/09 (0)
    • RE: How do I tell if I have a 200C or 200CX - SQLGuy 20:24:54 03/08/09 (5)
      • RE: How do I tell if I have a 200C or 200CX - PaulMC 18:02:57 03/09/09 (4)
        • RE: How do I tell if I have a 200C or 200CX - SQLGuy 21:08:05 03/09/09 (3)
          • RE: How do I tell if I have a 200C or 200CX - PaulMC 05:34:38 03/10/09 (2)
            • RE: How do I tell if I have a 200C or 200CX - SQLGuy 18:12:16 07/13/09 (1)
              • RE: How do I tell if I have a 200C or 200CX - PaulMC 14:54:53 07/17/09 (0)

Post a Followup:

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Power Forum ]
[ Comment ] [ Edit ] [ Delete ] [ Copyright Warning! Click for Details ]

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2009, Audio Asylum, all rights reserved ] [ Go Green ] [ Take5 ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---