I have a 120v : 25v toroid, single primary and single secondary.
I'm trying to figure out if the secondary winding would be single ended or balanced - I'm assuming the latter. There is no center tap on the secondary, so I'm wonder how to measure voltage.
Plugged in, I can measure the 25VAC across the two outputs no problem. I was however expecting to get a 12.5 voltage from each of the two outputs to ground, but I don't get any measurement.
Should I be measuring the outputs from the secondary against the neutral wire going into the primary?
Apologies for what must be a silly question but I have a natural aversion to electric shocks and fire and the better half would not be amused by either.
Thanks
Cleet.
This post is made possible by the generous support of people like you and our sponsors:
Topic - Transformer secondary measurement - Cleet Torres 22:15:05 08/03/13 (5)
- RE: Transformer secondary measurement - tesla 19:16:54 08/05/13 (4)
- RE: Transformer secondary measurement - Cleet Torres 19:06:49 08/06/13 (3)
- RE: Transformer secondary measurement - tesla 18:52:02 08/07/13 (2)
- RE: Transformer secondary measurement - Cleet Torres 08:03:05 08/08/13 (1)
- RE: Transformer secondary measurement - tesla 18:34:49 08/08/13 (0)