In Reply to: sonic maximizer posted by GoWolfpack on January 12, 2007 at 06:33:13:
I picked one up used for like 15 bucks and thought I would try itI have only used the thing once in a DJ setup
I typed out snips from the manual
It is not word for word but it gives you the idea hereIt imparts a pre-determined phase correction to the high freqs
where most harmonic information exists. It breaks the signal into three sub-bands or groups;
Low freq group which is crossed over at 150hz, the mid xover@2500hz
and the high freq group that handles everything else up to 20k
Low group is delayed 2.5 milliseconds (below 150hz)
It has a control to set at flat or boost @50hz
Mids are delayed at .5 milliseconds while the highs are passed
through a voltage control amp. The high group is used as a point of reference to make dynamic amplitude corrections to the high freqs
RMS loudness detectors continuously monitor both the mids and high
freqs to compare the relative harmonic content levels of the two bands
and apply the appropriate amount of control voltage to the VCA
thereby determining the amount of high freq harmonic content present at the final outputBasically the thing delays parts of the bandwidth to the high end
and gives some kind of weird glazed sound to the highs
I can tell you that this thing sounds weird and generates alot
of harmonics when you put alot of the effect on a signalI think basically with a small amount of the effect it can be ok
I know my first impressions of it when I heard it on a system
was...there is something weird about that soundI had to filter out that bite your head off stuff it generated
from 2k to 6k with a 2/3octave eqThats all I can say and I hope this helps you a bit
Play with it
They are cheap in price
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: sonic maximizer - STUART 07:44:01 01/12/07 (0)