heya,
I am currently putting togething parts for new speakers im building.. and i decided to get some feedback from you guys, if there is something i could improve, or change... etc...
this is what i have picked out:woofer (2 in each box)
McBride VHP1500 15" foam edge paper cone woofer
8ohm
150w
24hz-2khz
56 oz magnettweeter
Eminence PSD3003-8 2" throat compression driver
8 or 16ohm
100wrms/800hz
150wrms/1000hz
freq. resp 800hz - 18 khzlense
sammi SH450 2" throat bolt-on constant directivity horn lens
outside dia 250x450mmso im going to have 2 15" drivers and 1 horn in each speaker...
im thinking of having the crossover set to roll over at 800hz... and i might inlcude two super tweeters (but then it will change from a 2way to a 3way speaker)Motorola 3" powerline bullet tweeter
impedance - high at low freq.
protected to 400w
1.8khz - 30 khzand if i add couple of those i would prolly roll the freq at 800hz and 5000hz..
if anyone has any suggestions please feel free to include your thoughts...
these will be used for 50/50 dj work/personal usage...
thanks, and hope to see some thoughts.. if any..
This post is made possible by the generous support of people like you and our sponsors:
Topic - Re: DIY project - cybercowboy 18:01:30 01/04/02 (1)
- Re: DIY project - Gepetto 11:20:39 02/10/02 (0)