In Reply to: Crossovers were do i use them? posted by Nttrbl on April 17, 2009 at 18:19:28:
First of all one amplifier is not gonna handle all of those loudspeakers
If you want to run a pair of the Yamahas off one channel on the amp
and the bass bins off the other channel on the amp you should be ok.
The xover goes AFTER the mixer then into the amp
Run out of the Mono output of your mixer into one side of the
xover
Run out of low output of the xover into one side of the amp
Plug your bass bins into that side of the amp
Run out of the High output on the same xover channel into the other
side of the amp and hook up two of the Yamahas to that side of the amp
Set the xover point anywhere from 100hz to 150hz
I prefer 150hz myself
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Crossovers were do i use them? - Pro Sound Guy 06:57:13 04/20/09 (5)
- RE: Crossovers were do i use them? - Nttrbl 15:54:58 04/20/09 (4)
- RE: Crossovers were do i use them? - Pro Sound Guy 06:53:37 04/21/09 (3)
- RE: Crossovers were do i use them? - Nttrbl 08:25:59 04/21/09 (2)
- RE: Crossovers were do i use them? - Pro Sound Guy 21:31:57 04/21/09 (1)
- RE: Crossovers were do i use them? - Nttrbl 01:29:01 04/22/09 (0)