|
Pro Audio Asylum Pro studio recording equipment and music production/industry. |
|
|
|
Pro Audio Asylum Pro studio recording equipment and music production/industry. |
|
In Reply to: Re: Continuing To Load Our Rears posted by Bill Fitzmaurice on June 6, 2005 at 04:51:27:
I was under the impression that "full range" meant anything below the HF crossover frequency. Then, let me know if this is a bad plan: The small/medium design I had in mind was to stack two DR15s (per side of stage) with the top one handling 800Hz & down, while the bottom one doubled the bass from about 100Hz and down; the HF would be handled by a BMS coaxial driver on a DDS horn from 800Hz & up. Only one active crossover point necessary! If you recommend that the DR15 not try to pass LF below a certain point for SR applications, it would be a good thing to know ahead of time!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Continuing To Load Our Rears - Cuppa Joe 19:55:41 06/06/05 (5)
- Re: Continuing To Load Our Rears - Bill Fitzmaurice 04:53:17 06/07/05 (4)
- Re: Continuing To Load Our Rears - Cuppa Joe 07:45:49 06/07/05 (3)
- Re: Continuing To Load Our Rears - Bill Fitzmaurice 08:24:09 06/07/05 (2)
- Re: Continuing To Load Our Rears - Bill Fitzmaurice 05:08:28 06/08/05 (1)
- Re: Continuing To Load Our Rears - Cuppa Joe 16:33:39 06/09/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
