In Reply to: RE: Intona USB 2.0 Hi-Speed Isolator _ does it re-clock ? posted by Ryelands on April 18, 2016 at 02:49:35:
Hi !
thank you very much for your kind and very valuable reply.
Regarding the " ADuM4160 is USB1 only " does this mean reduced speed ?
i am not at all in high-rez ... at max 16/48.
I found the following on the ADuM4160 datasheet ..." Low and full speed data rate: 1.5 Mbps and 12 Mbps "
and actuall i see a jumper on the board positioned for full speed.
And actually i am using a simple board now based on it.
Moreover the fact that " the ADuM4160 board needs an external PS " it is actually a plus for me because i can "inject" cleaner power in the usb cable downstream the isolator.
Main problem would be the introduction of jitter of any nature in the signal.
I do not have a clue about this however.
Thanks a lot again for the very helpful advice.
Kind regards,
bg
Edits: 04/18/16 04/18/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Intona USB 2.0 Hi-Speed Isolator _ does it re-clock ? - beppe61 03:24:57 04/18/16 (4)
- RE: Intona USB 2.0 Hi-Speed Isolator _ does it re-clock ? - Ryelands 03:55:27 04/18/16 (3)
- RE: Intona USB 2.0 Hi-Speed Isolator _ does it re-clock ? - beppe61 04:06:42 04/18/16 (2)
- RE: Intona USB 2.0 Hi-Speed Isolator _ does it re-clock ? - Ryelands 06:18:44 04/18/16 (1)
- RE: Intona USB 2.0 Hi-Speed Isolator _ does it re-clock ? - beppe61 07:37:58 04/18/16 (0)