In Reply to: Some of the older amps had lower voltages posted by Ralph on March 13, 2014 at 14:15:41:
but sometimes, on my workbench, if the wall voltage is a bit low, I see less than 130V. Don't know whether that's high or low on average.
Anyway, the point was that those Mundorf caps are not up to snuff and that at minimum 150V caps are required but at least 200V is preferred. Does that seem like OK advice? Thanks for the correction on the steady state DCV of the LV supplies.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I guess I measure about 132V, most days,... - Lew 16:32:52 03/13/14 (4)
- In the case of Billy's amps - Ralph 08:30:19 03/14/14 (3)
- Last Question? - Cousin Billy 10:02:10 03/20/14 (2)
- the downside - Ralph 10:44:01 03/20/14 (1)
- RE: the downside - Cousin Billy 13:08:36 03/20/14 (0)