In Reply to: MQ-565 posted by gluca on February 19, 2010 at 13:56:31:
Hello GL:Tell me what else you need to know...
nominally 7100 ohms CT with UL screen taps
8 and 16 ohm secondary taps
MOL of 17.5 watts
I can build these with nickel pinstriped lamination stack or
just good ole M6.Can give several choices in bell ends and finishes on bell ends.
published freq response of these guys was something like 6 hz to 60 khz
+/- 1db.Core design is good... allows for headroom... in other words dyna did not run the snot out of these trans... even with the power rating at 20 hertz.
Biggest problem with the Dyna designs is we're competing against every knock off and cloner on the planet... and the perception that these (generically) are as exciting as your dad's oldsmobile.
Like I said previously--- we stuck with the original blueprints (which we actually have) for the essentials of the design--- and made some marked improvements in insualting materials, core choices, and workmanship--- all of which yield a pretty decent output... again, especially if your building UL and using some global feedback in your design.
If anyone is interested in a pair of these please contact me at acrosound at aol dot com or give me a call 215***288***4816 (up to midnight east coast time).
MSL
Builder of MagneQuest & Peerless transformers since 1989
Edits: 02/19/10
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: MQ-565 - mqracing 17:45:52 02/19/10 (2)
- RE: MQ-565 - Ed Sawyer 20:06:01 02/21/10 (0)
- you have mail n/t - gluca 00:01:59 02/20/10 (0)