|
MagneQuest/Peerless Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
MagneQuest/Peerless Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: I made unofficial datasheets...with measurements posted by petercapo on April 16, 2015 at 08:34:10:
what you might consider doing is using your existing bell end caps. Like I said in my previous post the core dimensions are substantially the same as specified on the factory blue prints.
MSL
Builder of MagneQuest & Peerless transformers since 1989
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I made unofficial datasheets...with measurements - mqracing 20:02:28 04/16/15 (1)
- RE: I made unofficial datasheets...with measurements - petercapo 14:28:46 04/17/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
