Home High Efficiency Speaker Asylum

Need speakers that can rock with just one watt? You found da place.

RE: Electro-Voice Regal lll

Paul,
Thanks for the schematic! Just curious, what did you use for the low and high crossover frequencies?

I was hoping I could keep the speakers original in design but update it with new caps. That's not turning out to be the case. I checked with Bob Crites. He says he has NOS 16 ohm T35 diaphragms but wants $100 each installed. Through my research I have come to believe the MR-10 horns were 16 ohms in the Regal III. That would make the 5.7uF mid cap a little closer to what is expected. Since I'm not willing to drop $200-$400 on new 16 ohm diaphragms and since mine measure 8 ohms and new 8 ohm ones are readily available it makes sense to change the crossover & L-Pads to work with what I have.

What is the reason for the 16 ohm and why did 8 ohm become common? The following are the parts I'm considering. The L-Pads have me a little confused. There are different wattages & mono vs stereo.

https://www.parts-express.com/dayton-audio-dmpc-56-56uf-250v-polypropylene-capacitor--027-425#!

https://www.parts-express.com/dayton-audio-dmpc-20-20uf-250v-polypropylene-capacitor--027-436

https://www.parts-express.com/jantzen-audio-037mh-18-awg-air-core-inductor-crossover-coil--255-222

https://www.parts-express.com/jantzen-audio-065mh-18-awg-air-core-inductor-crossover-coil--255-236

https://www.parts-express.com/speaker-l-pad-attenuator-15w-mono-1-shaft-8-ohm--260-250

Craig


This post is made possible by the generous support of people like you and our sponsors:
  VH Audio  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.