In Reply to: altec 414-16b and 902-8t with 511b posted by walktheline26@hotmail.com on December 31, 2016 at 20:37:16:
Check out this thread for some ideas
on 414 implementations.
Once you decide on, and build, a cabinet,
you can start listening to a wide variety
of crossover points. First order is simple
and can be very beautiful. You will find out
which driver is most interesting to you
in a given frequency range.
I often prefer a larger coil and smaller cap
than what comes up on the calculator values.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Amandarae's beautiful thread - Mats Gunnars 11:41:17 01/01/17 (12)
- RE: Amandarae's beautiful thread - walktheline26@hotmail.com 21:59:28 01/01/17 (0)
- RE: Amandarae's beautiful thread - D Mike 17:00:26 01/01/17 (10)
- RE: Amandarae's beautiful thread - Randal P 17:41:48 01/01/17 (9)
- RE: Amandarae's beautiful thread - D Mike 05:39:24 01/02/17 (5)
- RE: Amandarae's beautiful thread - Randal P 08:49:58 01/02/17 (3)
- RE: Amandarae's beautiful thread - freddyi 12:34:13 01/02/17 (2)
- RE: Amandarae's beautiful thread - Randal P 06:20:16 01/03/17 (1)
- RE: Amandarae's beautiful thread - freddyi 16:02:48 01/04/17 (0)
- RE: Amandarae's beautiful thread - Randal P 08:48:24 01/02/17 (0)
- RE: Amandarae's beautiful thread - walktheline26@hotmail.com 18:02:03 01/01/17 (2)
- RE: Amandarae's beautiful thread - fred76 19:05:24 01/01/17 (1)
- Hmmmm - Uncle Mike 15:37:24 01/02/17 (0)