In Reply to: RE: New pair of DIY VOTT / A7-800 Crossovers almost done posted by used-hifi on March 26, 2016 at 07:33:23:
Lawrence,Thanks, but I actually avoid terminal connections, whenever possible, in my crossover execution. KISS rules.
Hard-wired, wires wrapped around and soldered, Wonder Solder Classic.
Partially-built photos ( 3 above ) show this.
On amplifier, I am converting this Easter weekend to Cardas Silver Rhodium short speaker posts / terminals, ( so I can swap for out-of-absolute phase recordings ). All else is soldered.
I also eliminated the terminal connections, on the stock ALTEC 515B and 802D drivers, and soldered the speaker wires directly to the tabs holding the voice coil wires, and tie-wrapped the speaker wire to the driver frame ( to eliminate damage from inadvertent tugs ).
That is better sounding to my ears !! Wonder Solder in all cases.
Jeff Medwin
Edits: 03/26/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: New pair of DIY VOTT / A7-800 Crossovers almost done - drlowmu 09:58:55 03/26/16 (5)
- RE: New pair of DIY VOTT / A7-800 Crossovers almost done - kyle 19:36:51 03/26/16 (4)
- RE: New pair of DIY VOTT / A7-800 Crossovers almost done - drlowmu 20:02:59 03/26/16 (3)
- Continuing the conversation Posted by used-hifi (A) on March 28, 2016 at 11:30:41 - The Bored 09:12:10 03/30/16 (0)
- RE: New pair of DIY VOTT / A7-800 Crossovers almost done - kyle 09:07:16 03/27/16 (1)
- RE: New pair of DIY VOTT / A7-800 Crossovers almost done - drlowmu 11:36:26 03/27/16 (0)