In Reply to: Jensen XP-101s posted by PeterI on September 23, 2015 at 16:43:09:
Not familier with that driver so....but on a typical standard driver:Remove diaphragm, use small brass or stainless steel wire brush near magnet area, brush clean. Blow out coil gap with air, use folded over masking tape to get anything magnetic out of the gap. Re-assemble.
Edits: 09/23/15 09/23/15
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Jensen XP-101s - Coner 16:54:55 09/23/15 (2)
- RE: Jensen XP-101s - PeterI 20:18:12 09/23/15 (1)
- RE: Jensen XP-101s - Coner 22:02:44 09/23/15 (0)