In Reply to: RE: To Bi or not to Bi, that is the question.. posted by belyin on July 2, 2015 at 22:40:27:
No, so far I have´nt made any measurements at the horns.
Perhaps a silly question, but as far as I understand, you let the HF drivers work below the horns acoustical cut off.
Could´nt this demage the drivers caused ny to long diagraphm extrusion (caused by no acoustical diagraphm loadig)?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: To Bi or not to Bi, that is the question.. - pix 12:37:05 07/03/15 (8)
- RE: To Bi or not to Bi, that is the question.. - Rod M 19:25:09 07/03/15 (6)
- RE: To Bi or not to Bi, that is the question.. - pix 23:05:52 07/03/15 (5)
- RE: To Bi or not to Bi, that is the question.. - Rod M 06:50:41 07/04/15 (1)
- RE: To Bi or not to Bi, that is the question.. - tomservo 14:30:37 07/04/15 (0)
- Of course - drlowmu 03:30:25 07/04/15 (2)
- Acoustical measurements or datasheet? - pix 10:47:42 07/04/15 (1)
- RE: Acoustical measurements or datasheet? - drlowmu 07:12:49 07/09/15 (0)
- RE: To Bi or not to Bi, that is the question.. - belyin 13:07:53 07/03/15 (0)