In Reply to: GPA Altec 414 alnico vs. MCM 55-1220 : WinISD posted by deathtube 667 on February 23, 2015 at 12:34:12:
Those would seem to be my T/S measurements... I'm pretty sure when I originally posted them I explained why Fs and Qts usually test high for me (drivers not broken in and sitting face up on the dining room table). Originally, and here again, take them as a single data point.
In any case, GPA publishes the T/S for those drivers. Again, use those and not mine.
I have mine in 4.5cu ft, tuned to around 28hz. I like them an awful lot. Keep in mind my amplifiers have 2-3ohm output impedence.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: GPA Altec 414 alnico vs. MCM 55-1220 : WinISD - nullspace 18:58:52 02/23/15 (5)
- RE: did you compare 414 to either 416 or 515? - deathtube 667 03:32:30 02/24/15 (4)
- RE: did you compare 414 to either 416 or 515? - nullspace 05:19:22 02/24/15 (3)
- RE: did you compare 414 to either 416 or 515? - deathtube 667 14:53:31 02/24/15 (2)
- RE: did you compare 414 to either 416 or 515? - nullspace 07:50:15 02/25/15 (1)
- RE: Altec 808-8A ... - deathtube 667 13:25:19 02/25/15 (0)