In Reply to: RE: Dayton Audio D250P-8 & 811B : impedance vs. Hz plots posted by freddyi on July 19, 2014 at 21:54:07:
Thanks for that info.
I looked a bit on the Altec Heritage site and didn't see a Zobel network for the HF horn.
I was not sure if I should use one or not, but the Dayton driver has a weird impedance graph compared to most I have studied.
The horn is crossing over first order at 1.8KHz.
I was looking at some compensation networks because the high Hz's start to roll off at about 10KHz as measured at my listening position.
Tom Brennan posted one that has a cap and resistor in parallel across the top of one of 2 series fixed resistors from + to - on the horn.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Dayton Audio D250P-8 & 811B : impedance vs. Hz plots - deathtube 667 04:23:40 07/20/14 (3)
- RE: altec compensation circuit... - deathtube 667 10:04:30 07/20/14 (2)
- RE: altec compensation circuit... - freddyi 13:36:07 07/21/14 (1)
- RE: compensation circuit...another try - deathtube 667 14:19:04 07/21/14 (0)