In Reply to: It's a signal-noise ratio issue posted by KCHANG on March 7, 2007 at 12:41:00:
The preamp is needed because I listen to records.
My preamp will put out a lot more voltage than just the CD player if I use a CD player as an input. Given that should I run 10vac or ??? into said crossover rather than the 2vac a straight CD connection would give? It is not a problem to pad after the crossover in either case. I don't think so well in dB's but I am thinking the standard for pro audio is 7vac in??? If so but I am converting XLR to single ended does that change anything? It is a TDM crossover.
This post is made possible by the generous support of people like you and our sponsors:
Topic - Made the switch from passive to active (long) - Sparky 19:37:55 03/06/07 (9)
- Re: Made the switch from passive to active (long) - Paul Joppa 20:49:44 03/06/07 (8)
- Re: Made the switch from passive to active (long) - Sparky 05:33:30 03/07/07 (1)
- Re: Made the switch from passive to active (long) - bzdang 12:50:46 03/07/07 (0)
- Do you think this is a factor with analog pro audio crossovers too? - Russ57 04:59:05 03/07/07 (5)
You can not post to an archived thread.