In Reply to: Re: Made the switch from passive to active (long) posted by Paul Joppa on March 6, 2007 at 20:49:44:
I am running an analog crossover. Do you think it is better for me to run a higher voltage in (from preamp), as in crank it up well past normal volume....and the attenuate on the output of the crossover to met amp input sensitivity?
Just to pick some numbers...say 2 volts out of CD and amp needs 2 volts to reach clipping.....what do you think the crossover would like to see. I am driving XLR inputs single ended.Russ
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Do you think this is a factor with analog pro audio crossovers too? - Russ57 04:59:05 03/07/07 (5)
- It's a signal-noise ratio issue - KCHANG 12:41:00 03/07/07 (4)
- In my case - Russ57 14:56:42 03/07/07 (3)
- Re: In my case - KCHANG 16:40:29 03/07/07 (2)
- Thanks, mostly looking for..... - Russ57 11:53:58 03/08/07 (1)
- Don't worry about it. - KCHANG 13:53:48 03/08/07 (0)