|
VK Music - Elekit & Triode Japan Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
VK Music - Elekit & Triode Japan Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: TU-882R Headphone Amp - Possible Mods posted by Mike C on April 12, 2016 at 17:18:23:
"What is the input impedance of the component you'll be feeding" This Mike, is the question asked on the V-Cap coupling cap calculator so I don't have to go back to school. The input impedance of the amp is stated at 50k, I measure 45kish. The headphones I use are 75 ohm and of course this is irrelevant. So then, the component I'll be feeding is the second stage of the tube at 1M. This is what I didn't get. The V-cap calculator works fine, gets around 3hz with 1 meg plugged in. A minus 3db at like 15hz should be ok shouldn't it?? This would mean much smaller than a .047 could be used?? Is it just a phase shift issue or would it be something else?? The next problem is how to get silk fibers into Pano caps? Great info, Thanks, Tweaker
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: TU-882R Headphone Amp - Possible Mods - Tweaker456 21:41:49 04/12/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
