Home Dynaco-Doctor Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Dynaco-Doctor Forum ]
[ Alert Moderator ]

Re:Does anyone know this setup

So I found that i'd wired the ports under the bias check ports for for the other two tubes respectively.

On the right side Id measured and set the voltage and both tubes measure .500v +/- .002 volts.


On the left side setting one tube to .490v yields .560v on the other tube. I guess they are no longer a balanced set. I wonder if the DC boas option can be added to the existing board I have and would it help. Clearly an unbalanced push/pull is no good for anyone

This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]