|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Input capacitance of PAS phono board (stock) posted by Wanderer on January 18, 2015 at 11:03:38:
I don't recall ever reading that spec. either. I'm sure someone has measured it at some point, but that's no help to you unless you can find their results.
Speaking of measuring capacitance, I learned on the Vinyl Asylum that measuring this in regards to phono stages, cables, etc. can't be accomplished with a simple capacitance meter. See link below, and good luck. If you DO find the answer, please post it. I'd like to put it into my Dynaco PAS information folder.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- In all the years I've been screwing around with Dynaco equipment - 1973shovel 05:55:11 01/22/15 (1)
- RE: In all the years I've been screwing around with Dynaco equipment - Wanderer 10:35:21 01/22/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
