The Pas is a recent purchase and was never run prior to the power supply replacement. Also replaced were the RCA board and power indicator lamp all frm tubes4hifi. The hum is in both channels. The hum reduces when at the mid position of attenuation. I was wondering if there was an issue with the pot itself or possibly the connected filter or resistor. All pots were cleaned prior to any work done. All grounds were reflowed, and solder flows were added around the gound on the line stage pc. I would appreciate your thoughts nd input.
Wayne
Glover
This post is made possible by the generous support of people like you and our sponsors:
Topic - Pas volume attenuators hum - wgloverr@yahoo.com 16:36:29 01/17/15 (6)
- RE: Pas volume attenuators hum - petercapo 17:42:44 01/17/15 (5)
- RE: Pas volume attenuators hum - wgloverr@yahoo.com 18:40:26 01/17/15 (4)
- RE: Pas volume attenuators hum - petercapo 19:09:25 01/17/15 (3)
- RE: Pas volume attenuators hum - wgloverr@yahoo.com 19:50:23 01/17/15 (2)
- A few other thoughts - petercapo 07:58:47 01/18/15 (0)
- RE: Pas volume attenuators hum - petercapo 21:20:02 01/17/15 (0)