|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover posted by petercapo on February 4, 2014 at 13:11:11:
The 62K and 510K resistors were chosen so that the effective impedance presented to the PAS line amplifier output stage (when combined with the load from the power amplifier) is correct for the proper operation of the tone controls.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - Joe Curcio 14:30:38 02/04/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]