|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover posted by petercapo on February 4, 2014 at 08:51:58:
Thanks. I read GP49's comments here: (Safe Short URL) :
http://alturl.com/spvqp
Regarding how to get the impedance right for a 100k ohm load.
My math takes me to believe that a 10m ohm resistor across the RCA output jack(s) would get me to almost 50k Ohms. The load that will make the PAS3 happy.
I've PM'd both of them to get their thoughts.
Randall Nerison
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - aguaazul@gmail.com 10:12:20 02/04/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
