In Reply to: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover posted by aguaazul@gmail.com on February 3, 2014 at 22:42:38:
AFAIK, with the x-mod done to the PAS (including the 1.0uF capacitor at the output), the minimum input impedance it would need to see is 100K.
Do you have the 1.0uF cap, or were the tone controls just bypassed without it being added? If you don't have the 1.0uF cap, you might even have a small DC offset at the output of the PAS. Worth checking.
You can try it, and if the crossover has a level control, you might be able to compensate for the bass rolloff.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - petercapo 06:23:41 02/04/14 (3)
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - aguaazul@gmail.com 08:39:23 02/04/14 (2)
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - petercapo 08:51:58 02/04/14 (1)
- RE: PAS3 - Tone Controls Bypassed - Need to connect up to a 50k Ohm Active Crossover - aguaazul@gmail.com 10:12:20 02/04/14 (0)