In Reply to: RE: help with Dynaco Pas line stage circuit check posted by xaudiomanx on May 3, 2013 at 19:13:11:
hi, I've gone back to Circio instructions and installed .33uf 400v caps as output caps , the first .0075 for each channel is still replaced with wire,some other forums I have read mention that you need another cap instead of the jumper wire so that there are two caps after the final stage otherwise you get DC at the output, I'm currently getting 0.4mv DC on the output RCA's, is it supposed to be zero?
Thanks for your help
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 21:55:31 05/03/13 (11)
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 03:15:04 05/04/13 (10)
- RE: help with Dynaco Pas line stage circuit check - xaudiomanx 04:01:39 05/04/13 (9)
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 06:11:51 05/04/13 (8)
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 06:31:08 05/04/13 (7)
- RE: help with Dynaco Pas line stage circuit check - xaudiomanx 16:35:51 05/04/13 (6)
- RE: help with Dynaco Pas line stage circuit check - xaudiomanx 16:42:36 05/04/13 (5)
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 21:50:50 05/04/13 (4)
- RE: help with Dynaco Pas line stage circuit check - xaudiomanx 16:56:14 05/06/13 (3)
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 21:39:30 05/06/13 (2)
- RE: help with Dynaco Pas line stage circuit check - xaudiomanx 05:14:06 05/07/13 (1)
- RE: help with Dynaco Pas line stage circuit check - gdlen1@yahoo.co.nz 05:23:06 05/07/13 (0)