Looks like I have a bad volume pot. Channel balance changes with volume level. Just after the 1/2 point, balance moves far right.
When I change the pot, I will bypass the loudness switch. (Cut all connections to the loudness switch, connect 4.7k resistors between taps 1-4 and 2-8 correct ?)
I anticipate using the RS 100k Alps pot.
What will happen to gain if I make these 2 changes ? Will I have to turn the volume control up or down vs stock to get the same level ?
Best,
Ross
This post is made possible by the generous support of people like you and our sponsors:
Topic - PAS Volume Pot Problem - Ross 07:20:15 02/12/12 (10)
- RE: PAS Volume Pot Problem - GP49 12:20:57 02/12/12 (9)
- RE: PAS Volume Pot Problem - Ross 13:24:41 02/12/12 (8)
- RE: PAS Volume Pot Problem - GP49 15:22:44 02/12/12 (7)
- RE: CAE PC-7A output wiring questions - Joe Curcio 18:16:46 02/12/12 (6)
- RE: CAE PC-7A output wiring questions - GP49 19:36:12 02/12/12 (5)
- RE: CAE PC-7A output wiring questions - Joe Curcio 15:52:05 02/13/12 (4)
- RE: CAE PC-7A output wiring questions - Flyquail56 19:17:40 02/26/12 (0)
- RE: CAE PC-7A output wiring questions - GP49 16:38:08 02/13/12 (2)
- RE: CAE PC-7A output wiring questions - 54dynaco 09:16:58 05/11/12 (1)
- RE: CAE PC-7A output wiring questions - GP49 22:44:24 05/11/12 (0)