Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Dynaco-Doctor Forum ]

---

[ Alert Moderator ]

---

RE: Was: Re: PAS Transformer Replacement

Posted by xaudiomanx (A) on March 21, 2011 at 17:49:01

In Reply to: Was: Re: PAS Transformer Replacement posted by sbalfour on March 20, 2011 at 17:49:25:

Another way around all this mess is the minimum, to build an outboard filament supply on another chassis with an umbillocal cord connecting the filament supply to the preamp chassis or you could go one step even better and build a much better full power supply using chokes and caps for the filtering on a separate chassis and have the proper voltages with more than enough current to supply the preamp.

This could all be done very easily and it will look great. I have done this for many of my friends and clients and all were pleased with the results. You could even build a fully regulated HV B+ supply and a fully regulated filament supply on another chassis.

The probelm with any mod is room to put the new components and there is very little extra room on Dynaco amps and preamps.

Here are just two of the outboard power supplies I built with supplied chassis. These were both for Dynaco Pas projects.

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---