|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Re: Need Clear Diagram How to Connect Volume Pas2 posted by Carl B. on June 11, 2006 at 15:55:57:
Carl,
For sake of clarity, the loudness taps are the two connections on the right side of the potentiometer when looking at it from inside the chassis. The DPDT switch below the pot is the loudness switch.Again using the numbering on page 11, connect a 0.1 uF cap from loudness tap 7 to loudness switch lug 4, second 0.1 cap from loudness tap 8 to switch lug 1.
Connect a solid wire from loudness tap 7 to switch lug 5, second solid wire from loudness tap 8 to switch lug 2.
Finally connect a 4.7K resistor from volume pot lug 4 to switch lug 1, and the second 4.7K resistor from balance pot lug 6 to switch lug 4.
Solder all your connections, and you're back to stock. BTW, you can get the caps from many sources, Antique Electronic Supply, Mouser, Digi-Key, and others. The originals are 0.1 uF/200 volt. If 0.1/400 volt are easier to find, they will be fine, too.
If all of this step-by-step isn't quite clear, feel free to email me with your snail-mail address, and I can send you a photocopy of the original pictorial diagram from the assembly manual.
Regards,
Mike
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Need Clear Diagram How to Connect Volume Pas2 - Flyquail56 19:41:23 06/12/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
