|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Re: 10 and 8 go to the preamp sockets via the 10 ohm resistors, don't they? posted by Carl B. on June 11, 2006 at 05:31:38:
Terminals 8,9, and 10 are all a common ground so it really doesn't matter. Make sure to have a 10 ohm resistor, not 10K in series with the (between) the RCA outside shell and driver board ground on both sides with no other wiring attached to the RCA shell. There will be 2 extra 10 ohm resistor from the original mono/stereo switch that can be removed as well as any wiring.
Russ
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: 10 and 8 go to the preamp sockets via the 10 ohm resistors, don't they? - Russ57 07:08:40 06/11/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
