|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Need Clear Diagram How to Connect Volume Pas2 posted by Carl B. on June 10, 2006 at 19:31:50:
Most, but perhaps not all of what you need is at *Replacing the PAS Selector Switch* under Joe's Tech Support at the top of the page here. A diagram is on page 11. The only change from stock in Joe's diagram is that the loudness switch is deleted from the circuit. Don't connect the 47K resistors as shown, but instead re-connect the 0.1 caps to the loudness taps on the pot (assuming you left them attached to the slide switch). That should get you back to stock configuration.Best regards,
Mike
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Need Clear Diagram How to Connect Volume Pas2 - Flyquail56 06:56:26 06/11/06 (3)
- Re: Need Clear Diagram How to Connect Volume Pas2 - Carl B. 15:55:57 06/11/06 (1)
- Re: Need Clear Diagram How to Connect Volume Pas2 - Flyquail56 19:41:23 06/12/06 (0)
- Re: Need Clear Diagram How to Connect Volume Pas2 - Carl B. 15:24:12 06/11/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]