Home Dynaco-Doctor Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

Re: Where does the negative wire go from pin to driver board

ok, I got you. the 10,8 are for the rca ground. I have 1k resistors on 22,23,1,2. I am not sure about the .02uF "3 legged cap" connected to quad cap ground. I don't see any legged cap there. There are only 2 wires connected to my quad cap ground. The ground going to my driver board and the ground for my curcio cap board. I see only a ceramic round like disc cap with 3 wires coming out of it soldered to my 3 hole terminal strip that I purchased from curcio for his cap board. Can you email me at: carl.barbieri@sympatico.ca and I can send you pics of my amp.thanks


This post is made possible by the generous support of people like you and our sponsors:
  McShane Design  


Follow Ups Full Thread
Follow Ups
  • Re: Where does the negative wire go from pin to driver board - Carl B. 04:58:31 06/11/06 (1)


You can not post to an archived thread.