Re: Yes, you can but....

Dynaco-Doctor Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

In Reply to: Re: Yes, you can but.... posted by chris on September 10, 2003 at 12:42:41:

You don't need the driver board just the grid resistors. But again if you have the board it is easy to just use it and pull the 7199 tubes. You must have the output transformers and they must be connected to a suitable dummy load such as a 40 watt non-inductive 8 ohm resistor. I suppose one could use a resistor instead of the output transformers but I figured you did have the transformers and that would be the easy way.

Russ

This post is made possible by the generous support of people like you and our sponsors:

Schiit Audio

Follow Ups Full Thread

Topic - Ghetto Tube Matcher - Chris 02:33:50 09/10/03 (5)

Re: Yes, you can but.... - Russ57 07:25:14 09/10/03 (3)

Re: Yes, you can but.... - chris 12:42:41 09/10/03 (2)

Re: Yes, you can but.... - Russ57 16:15:39 09/10/03 (1)

Re: Yes, you can but.... - chris 12:08:30 09/11/03 (0)

Re: Ghetto Tube Matcher - rosco 05:00:21 09/10/03 (0)

Follow Ups

Re: Yes, you can but.... - Russ57 16:15:39 09/10/03 (1)

Re: Yes, you can but.... - chris 12:08:30 09/11/03 (0)

You can not post to an archived thread.