C4S question

Bottlehead Forum

Welcome! Need support, you got it. Or share you ideas and experiences.

Hey-Hey!!!,
Is it possible to take signal out of the plate load circuit 'above' the current set resistor? should have the same effect as with the MOSFET ccs,in taking signal from the lower source, nice low output impedance.
Has anybody tried this? it looks to me like if it works, you'd be able to use a single tube and eliminate the cathode follower. Which would open up a slightly larger choice of tubes to wire it for, IFF you don't need the cathode follower to reduce output z....
regards,
Douglas

This post is made possible by the generous support of people like you and our sponsors:

Schiit Audio

Topic - C4S question - Sector-7G 11:20:50 06/02/03 (3)

This may be slightly similar to Gizmo's Moscode output stage. - VoltSecond 00:03:30 06/03/03 (0)

Re: C4S question - Paul Joppa 13:58:23 06/02/03 (1)

well... - Sector-7G 14:35:28 06/02/03 (0)

You can not post to an archived thread.