Paramour C4S plus Voltsecond Hum and Noise Reduction Mod

Bottlehead Forum

Welcome! Need support, you got it. Or share you ideas and experiences.

161.34.126.186

Has anyone out there put both the C4S *and* Voltsecond hum and noise reduction mods into a Paramour? I did read an earlier post on the subject but I'm still not completely clear on the details. Is it a case of installing the C4S mod using the new "extra filtered" B+ at pin 20 instead of the stock pin 15 B+ ? i.e. running the C4S 15k 2W from pin20 instead of pin15 to the C4S board. I'm just abit concerned that the original stock pin 15 was 386 VDC, whereas the VS mod pin 20 is reduced to 358VDC. Is this a problem for the C4S operation? (I already have the VS mod in my Paramours - a big improvement - and am keen to reduce the hum abit more)
Thanks
Rich
Sketch of the Voltsecond Hum reduction mod

This post is made possible by the generous support of people like you and our sponsors:

Atma-Sphere Music Systems, Inc.

Topic - Paramour C4S plus Voltsecond Hum and Noise Reduction Mod - RichW 05:00:26 04/27/01 (5)

Re: Paramour C4S plus Voltsecond Hum and Noise Reduction Mod - Gordon 10:59:30 04/27/01 (4)

"definition and speed"... - mrh (Mark Hardy) 12:02:55 04/27/01 (2)

Paramours & 12AT7 Tube Rolling - Gordon 14:27:38 04/27/01 (1)

Foreplay Pads - Paul Joppa 22:22:20 04/28/01 (0)

Re: Paramour C4S plus Voltsecond Hum and Noise Reduction Mod - RichW 11:09:35 04/27/01 (0)

You can not post to an archived thread.