|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
|
|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
In Reply to: The nuts won't start on the screw! posted by VoltSecond on April 22, 2001 at 15:25:32:
Thanks for all the advice, but I re-measured the exposed bolt and it is only 1/4" in length. When you add the shoulder washer and the lock washer, there is absolutely no room for a nut - trust me on this. Even when I follow everyone's input, I wouldn't be able to turn the nut even one revolution. I'm doing all this when the transformer isn't even on the plate ... the plate adds a little bit of additional thickness (even when the shoulder washers are properly seated) so installing the washers or the solder lug is out of the question. In theory, I could sand each of the shoulder washers to make them thinner, but that seems to counter intuitive.I'll call Bottlehead today and see what they can tell me ....
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- There just isn't enough bolt to work ... - Vinyl_Junkie 09:03:34 04/23/01 (3)
- Re: There just isn't enough bolt to work ... - johng 19:24:04 04/23/01 (0)
- Re: There just isn't enough bolt to work ... - boatshed 10:19:42 04/23/01 (0)
- Yep...looks like you will need longer bolts for sure - RBP 09:51:18 04/23/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
