Paramour driver to output cap update

Bottlehead Forum

Welcome! Need support, you got it. Or share you ideas and experiences.

209.180.137.243

A while ago I had put a $5 Aeon 0.33 uF 630V Polypropylene and tin foil cap across the original Paramour SRPP to 2A3 grid coupling capacitor. I also placed an additional 230K resistor 1/4W from the 2A3 grid to ground.
I reported the midbass was a bit off with the dual capacitor combination. With one lead of the original coupling capacitor cut in half, the midbass problem cleared up a bit. The improvement with the Aeon capacitor is subtle, but I like this capacitor/resistor change. Later on, I'll completely remove the original capacitor.
Note: I still have my original lossy Parafeed circuit installed.

This post is made possible by the generous support of people like you and our sponsors:

Sonic Craft

Topic - Paramour driver to output cap update - VoltSecond 20:25:56 12/19/00 (0)

You can not post to an archived thread.