|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
|
|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
In Reply to: Paramour HUM posted by Patrick on November 17, 2000 at 17:36:36:
I talked to Doc about this too. There is a misprint in the manual. The very last item at the bottom of page 39 should read "Solder the resistor lead to" (it continues on the next page) "the cupped end of the RCA jack's center post."The reference to the 3' piece of 20 ga. magnet wire should be ignored. Instead you should (on page 40) "Cut a three inch piece of yellow offcut wire and strip both ends." and go on from there.
I also have a bit of hum but you can only hear it when you get close to the speaker.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Grounding RCA - Marting 05:41:20 11/18/00 (5)
- Doc, you should post corrections to the manual! - Patrick 09:06:07 11/18/00 (4)
- Summary of Paramour issues - VoltSecond 18:48:01 11/18/00 (3)
- Link to summary of Paramour contruction notes from Forum. - VoltSecond 22:45:32 11/18/00 (2)
- woohoo! - Doc B. 08:50:03 11/19/00 (1)
- Thanks Voltsecond and Doc! (nt) - Patrick 08:59:03 11/19/00 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
