|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
|
|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
In Reply to: Re: Attention Bottlehead Corp: help needed! posted by Wes on November 11, 2000 at 23:23:07:
When I got to the "Ranch" on Monday, Doc showed me the Hammond transformer and we discussed this again. I had forgotten to mention that you should use a drop of either fingernail polich remover, or acetone to help dissolve the varnish between the nut and the bottome lamination before you try to loosen the nut.Also, my memory failed me when I said "remove the washer". I should have said - remove the nut...and later - replace the nut (not the washer) after placing on the second shoulder washer under the chassis. In other words, there are no washers other than the shoulder washers in this situation.
Hope this clears up the OoPs!
-Wes
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Amendment to post above - Wes 21:20:46 11/13/00 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
