|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
|
|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
In Reply to: Attention Bottlehead Corp: help needed! posted by maldar on November 11, 2000 at 09:02:48:
Hi Malder!Yes, Doc and I discussed this problem a few days ago after we heared of it from another customer. This production run of transformers has bolts in them that are a bit shorter than what we saw in the first run. Now, lets see if I can recall the fix that Doc B told me.
Take the nuts and washers off of the bottem of the transformer. (Handle the transformer carefully so that the laminations do not separate). (For each bolt) - slip a shoulder washer on so that it contacts the bottom lamination of the tranny. Now mount the tranny with a shoulder washer on each of the four bolts onto the top of the chassis plate. Now, from the bottom of the chassis, slip another shoulder washer on , then slip that washer that you had removed on, then the nut - and sinch it up. There should (barely) be enough threads left to tighten it up. If not, email me back and I'll ask Doc on Monday if I am remembering this correctly, and I'll tell you what he says.
Hope this helps!
-Wes
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Attention Bottlehead Corp: help needed! - Wes 23:23:07 11/11/00 (1)
- Amendment to post above - Wes 21:20:46 11/13/00 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
