In Reply to: RE: Question regarding using Quickie in crossover posted by Skip Pack on September 15, 2009 at 09:13:37:
Thanks for the reply.
Theoretical attenuation in the xover is only 3.5dB, so I figure all I need is about 6dB max and attenuate from there. I have to assume the Quickie will have more than that.
I was also wondering about the output Z, since I plan to use my Paramour upgrade trannies for the headphone Quickie and not this one. The original Paramour OT's probably are not the best fit to drive bass amps, so I would probably go stock or with 10K:600 stepdowns (so I would then need another 4X gain).
So yeah, knowing the output Z would be nice. I was hoping to get it from the schematic. Also to find out what pot is being used, since I have an Alps Black Beauty 100K log that's been hopping from project to project. But if this stuff is all in the parts list/schematic, I can wait.
There seem to be quite a few nice applications for this product. Nice and quiet DHT is always in demand.
Triamp... Take a load off!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Question regarding using Quickie in crossover - artsybrute 09:53:17 09/15/09 (0)