Home Bottlehead Forum

Welcome! Need support, you got it. Or share you ideas and experiences.

RE: Input transformer and volume control

Most transformers like to work into the load for which they are designed; otherwise the high frequency response can get off kilter. So usually you would us a transformer first (say, 10K to 10K ohms - a "bridging" transformer, in studio parlance), then a pot of matched impedance (i.e. 10K ohms). This also makes it easy to hook it up for a balanced line input.

Now you said "mic transformers" - not sure what you are thinking there. But if you have a low-impedance primary on the transformer, perhaps 600 ohms, you can find matched impedance attenuator which presents a 600 ohm impedance to its source and to its load; such an attenuator can go before or after a 600 ohm transformer winding because its impedance stays fixed.


This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  


Follow Ups Full Thread
Follow Ups
  • RE: Input transformer and volume control - Paul Joppa 20:53:09 09/14/09 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.