74.64.70.17
In Reply to: RE: Not to be a contrarian, but... posted by Phil Sieg on May 05, 2009 at 13:49:03
It will work however it gets done. It just won't work as well :^]
According to the values shown in the link, I still have to adjust for tiny currents. So I would still need to put in a balance pot. After that I want to use a single current sink for the push pull pair. And there's a ton of new stuff in this rev, so I just want to get it up and running first without getting fancy.
Maybe it's not so bad. If I can figure out the theory a little better by the time I start wiring that stage (the sockets are already in), and I figure out where to put the pot and how to adjust it, then I'll do it. But first I need to make sure that I won't get grid current if something goes wrong in the cathode web. There are some mighty fine wires in the SUT. I vacillate. No I don't. Yes I do.
Just don't tell me I have to build a whole microphone next.
Triamp... Take a load off!
Follow Ups:
Post a Followup:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2009, Audio Asylum, all rights reserved ]
[ Go Green ]
[ Take5 ]